New York, NY (December 12, 2013)—Audio-Technica has released its AT-DMM828 Digital Matrix Mixer, a microprocessor-controlled, programmable, automatic-switching eight-channel matrix mixer. Designed to keep the number of open microphones to a minimum, thus reducing background noise, the mixer also features “correlation,” which analyzes and interprets redundancy of source material between channels in real time and may in turn favor the dominant channel, simplifying the layout/output and reducing feedback, phase issues etc.
The AT-DMM828 can be used with low-impedance dynamic or condenser microphones (including wireless microphone systems), as well as line-level sources. Each of the eight balanced inputs provides switchable 48-Volt phantom power; attenuation is also selectable on each input to allow use with line-level signals. The mixer’s outputs are balanced and non-inverting. All audio connections terminate in block screw connectors.
Up to 16 units of AT-DMM828’s (a total of 128 channels of inputs) can be daisy-chained via CAT5e cable, which carries control bus, audio, and configuration data between mixers. Multiple mixers linked in this way will operate as if they are a single mixer. Therefore, microphones activated on any mixer will cause the appropriate switching functions to occur.
Each AT-DMM828 includes two separate external control system interfaces: Individual channel contact closures (via DB25 connector) and PC control (via RS232 connector or USB). The RS232 connector can also be used to connect an external third-party control system (e.g. Crestron® or AMX®) using “open disclosure communication protocol” to control the mixer.